AIRTACUK
ASG / KWA CZ SHADOW 2 to MP5 HPA Adapter
WE CAN BUILD THIS ADAPTER FOR YOU - Please check our gas magazine section for the gas magazine or parts you require. If you add these to your cart, we can build your adapter for you
If unavailable, we provide magazine / feed lip install instructions here
ASG / KWA CZ SHADOW 2 to MP5 HPA Adapter
Open Mon-Thu 4-6pm
Unit 27/28
Ballymena Business Centre
Galgorm BT42 1FL
United Kingdom
These adapters are made to fit your existing GBB magazines, and include a Single Stack adapter, as well as a lanyard loop delete, allowing the adapter to sit flush with the base of the pistol.
Full support and lifetime warranty is offered for these products.
HOME INSTALLATION
HPA ADAPTER
Installation is simple. Remove your gas base by knocking out the two large pins at the bottom of the mag (they can be knocked out from either side). Knock out the small pin in the BB channel of the magazine. Remove the spring and follower, and insert our single stack adapter into the magazine.
Place the O ring from the gas base plate of the Shadow 2 mag onto our adapter, and insert into magazine. Using the clamp to apply compression, line up the pin holes and fully re-insert one pin at a time. You’re then good to go!
MP5 HPA Adapter Info
- Replaceable Feed Tube
- Replaceable Feed Tube
- Compatible with all CYMA MP5 Mid Caps (65 round metal, 120/130 round metal, Straight, Novritsch Straight, Bullet Window). Available Here
- Straight Magazines will follow grip of pistol/SMG
- Small rear tabs can be filed down to accomodate out-of-spec magazines (shown in blue on image below)
- BB Retention drops only 2 BBs when changing magazine
- Magazine Insertion will be tight for first few insertions, this is to provide perfect fit
Newer MP5 adapters include changeable shims, which can be removed with the included hex key.
- NO SHIM - CYMA 65RND (SHORT CURVED)
- S1 SHIM - CYMA 110RND (STRAIGHT)
- S2 SHIM - CYMA 130RND (PLASTIC CURVED WITH BULLET DETAIL/120 RND METAL CURVED