HPA SAFETY
The maximum working pressure of all of our HPA adapters is 150PSI unless otherwise stated. They are tested to a far higher pressure than this, but 150PSI should never be exceeded to ensure your safety and the longevity of your adapter.
Eye protection should be worn at all times when operating/using Airsoft equipment or any equipment under pressure.
If testing for a seal, do not hold the adapter against your ear. Place it in, or spray soapy water onto the adapter, and check for bubbles. Pressurised air when released from an outlet valve can cause permanent hearing damage.
Do not place any body part over any outlet of high pressure air
Always confirm the output pressure of your regulator before connecting it to any HPA adapter or HPA engine.
Ensure your regulator is maintained, and in good working order. If the behaviour of the regulator changes, do not continue to use it. Consult the regulators manufacturer or seek professional advice from ourselves or another manufacturer/retailer of HPA equipment.
Do not place any oils into the fill valve of your tank. Always ensure the fill nipple cover is in place and that the fill valve is free of debris. Never fill or use an out of test HPA tank. Never fill or use a damaged tank, line or regulator.
NEVER CONNECT YOUR HPA LINE TO THE FILL VALVE OF YOUR TANK. ONLY CONNECT YOUR LINE TO THE OUTPUT OF YOUR SECONDARY REGULATOR ONCE THE PSI OF THE REGULATOR IS CONFIRMED SAFE. DOING SO WILL CAUSE CATASTROPHIC FAILURE OF YOUR LINE, HPA ENGINE OR HPA ADAPTER, AND MAY CAUSE SERIOUS INJURY