Photo of AIRTAC Raffica M93R to MP5 HPA Adapter
Photo of AIRTAC Raffica M93R to MP5 HPA Adapter with mag

AIRTACUK

Raffica M93R MP5 HPA Adapter

£49.99

Earn [points_amount] when you buy this item.

Quantity:
Pickup available at Open Mon-Thu 4-6pm Usually ready in 2-4 days

Raffica M93R MP5 HPA Adapter

Open Mon-Thu 4-6pm

Pickup available, usually ready in 2-4 days

Unit 27/28
Ballymena Business Centre
Galgorm BT42 1FL
United Kingdom

07473913372
In stock

These adapters are made to fit your existing GBB magazine, and includes a Single Stack adapter.

Full support and a lifetime warranty is offered for these products.

HOME INSTALLATION

Installation is simple. Remove your gas base by knocking out the two large pins at the bottom of the mag (they can be knocked out from either side). Knock out the small pin in the BB channel of the magazine. Remove the spring and follower, and insert our single stack adapter into the magazine.

Place the O ring from the gas base plate of the M93R mag onto our adapter, and insert into magazine. Using the clamp to apply compression, line up the pin holes and fully re-insert one pin at a time. You’re then good to go!



DO NOT EXCEED 150PSI WITH ANY AIRSOFT HPA ADAPTER. 
ALWAYS USE AIR REGULATED BY A SECONDARY REGULATOR (EG AT200, WOLVERINE STORM, POLARSTAR MRS).
CHECK YOUR PSI BEFORE CONNECTING AIR TO A HPA ADAPTER.
NEVER CONNECT OUR EQUIPMENT TO PAINTBALL AIR TANKS OR CO2 TANKS.
NEVER CONNECT OUR EQUIPMENT TO A TIPPMAN STYLE HPA LINE