AIRTACUK
Modify PP2k to MP5 HPA Adapter
Earn [points_amount] when you buy this item.
Modify PP2k to MP5 HPA Adapter
Open Mon-Thu 4-6pm
Unit 27/28
Ballymena Business Centre
Galgorm BT42 1FL
United Kingdom
Includes single stack adapter and HPA adapter only. Designed and tested around CYMA Mid-Cap MP5 mags. Designed to be fitted to the short PP2k gas magazines.
Assembly
1) Unscrew the three screws in the bottom of the magazine. Remove the gas plate, spring and follower.
2) Insert the single stack adapter into the gas magazine
3) Fit the gasket to the Airtac HPA adapter ( at this stage you can apply a large amount of silicone oil to the gasket to aid insertion. Its a tight fit to ensure good seal )
4) Place the HPA Adapter into the magazine. Screw the screws back in, tightening the rear screw in first, and then the two side screws in small increments. Do not over tighten.
5) Go have fun!
DO NOT EXCEED 150PSI WITH ANY AIRSOFT HPA ADAPTER.
ALWAYS USE AIR REGULATED BY A SECONDARY REGULATOR (EG AT200, WOLVERINE STORM, POLARSTAR MRS).
CHECK YOUR PSI BEFORE CONNECTING AIR TO A HPA ADAPTER.
NEVER CONNECT OUR EQUIPMENT TO PAINTBALL AIR TANKS OR CO2 TANKS.
NEVER CONNECT OUR EQUIPMENT TO A TIPPMAN STYLE HPA LINE
MP5 HPA Adapter Info
- Replaceable Feed Tube
- Replaceable Feed Tube
- Compatible with all CYMA MP5 Mid Caps (65 round metal, 120/130 round metal, Straight, Novritsch Straight, Bullet Window). Available Here
- Straight Magazines will follow grip of pistol/SMG
- Small rear tabs can be filed down to accomodate out-of-spec magazines (shown in blue on image below)
- BB Retention drops only 2 BBs when changing magazine
- Magazine Insertion will be tight for first few insertions, this is to provide perfect fit
